Bb-electronics EIRP305-T - Quick Start Guide User Manual download pdf

EIRP305-T-1012qsg

Quick Start Guide

Elinx PoE Ethernet Switch

EIRP305-T

Items Included

Hardware Installation

LED Chart

Ports

Installation Complete

o Ethernet Switch

o CD with Support Manual

o This Quick Start Guide

o Panel Mount Bracket

1. Select a mounting location and install the

switch onto a piece of DIN rail or use the

included panel mount brackets for wall or

panel mounting

2. Connect power to the switch

 48 VDC

 If redundancy is desired be sure to

connect two separate power supplies by

using the two DC inputs on the terminal

blocks

 If only one power input is used the Fault

LED will light (this is normal)

LED Description

Green Power input 1 is active

Off Power input 1 is inactive

Green Power input 2 is active

Off Power input 2 is inactive

Red Power input 1 or 2 is inactive

Fault

Off

Power input 1 and 2 are both

active, or no power is present

Green

The port is supplying power to

the connected device

FWD

(1 to 4)

Off

No device attached or no power

being supplied

Green Connected to network

Flashing Networking is active

RJ-45

Upper LED

Off Not connected to network

Yellow Full-duplex link

Flashing Collision occurs

RJ-45

Lower LED

Off Half-duplex link or link down

RJ-45 ports: The RJ-45 ports auto-sense for 10 or 100 Mbps

device connections. The auto MDI/MDIX feature allows

connections to switches, workstation and other equipment

without changing straight through or crossover cabling. The

charts below show the cable pin assignments for straight

through and crossover cables.

PoE ports: The PoE ports on this switch follow Alternative A

standards and are limited to 15.4 Watts of power output per

port. Ports 1 thru 4 support the IEEE802.3af standard and

are classified as (PSE) power sourcing equipment, which

means they can be used to power (PD) powered devices.

MDI Cable Pinout

Pin Signal

1 Tx+

2 Tx-

3 Rx+

6 Rx-

MDI-X Cable Pinout

Pin Signal

1 Rx+

2 Rx-

3 Tx+

6 Tx-

1. Auto MDI/MDI-x is

supported. A straight

through or cross-over

cable may be used.

2. 10/100 auto

negotiation and full/half-

lex are su

orted.

1. When the network cables are attached and power

is applied, installation is complete.

2. The switch will automatically discover network

devices, populate its MAC address table, and

pass traffic to the appropriate ports.

Quick Start Guide 1

Summary of Contents

Page 1 - Quick Start Guide

EIRP305-T-1012qsg Quick Start Guide Elinx PoE Ethernet Switch EIRP305-T Items Included 12 Hardware Installation 3 LED Chart 4 Ports 5 Install

Comments to this Manuals

No comments

Bb-electronics EIRP305-T - Quick Start Guide User Manual

Browse online or download User Manual for Accessories communication Bb-electronics EIRP305-T - Quick Start Guide. B&B Electronics EIRP305-T - Quick Start Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Accessories communication Bb-electronics EIRP305-T - Quick Start Guide