Bb-electronics NTPS-48-5 - Datasheet User Manual download pdf

CS10.481

C–Series

48V, 5A, SINGLE PHASE INPUT

Nov. 2006 / Rev.1.1 DS-CS10.481-EN

All parameters are specified at 48V, 5A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0 Germany

1/20

POWER SUPPLY

■ AC 100-120 / 200-240V Auto Select Input

■ Efficiency up to 91.6%

■ Width only 60mm

■ 20% Output Power Reserves

■ Full Output Power Between -25°C and +60°C

■ Minimal Inrush Current Surge

■ 3 Year Warranty

1. GENERAL DESCRIPTION

2. SHORT-FORM DATA

Output voltage DC 48V

Adjustment range 48 - 52V

Output current 5.0 – 4.6A ambient <60°C

6.0 – 5.5A ambient <45°C

Output power 240W ambient <60°C

288W ambient <45°C

Output ripple < 100mVpp 20Hz to 20MHz

Input voltage AC 100-120 /

200-240V

Auto-select Input

Mains frequency 50-60Hz ±6%

AC Input current typ. 3.73 / 2.23A at 120 / 230Vac

Power factor typ. 0.59 / 0.51 at 120 / 230Vac

AC Inrush current typ. 3A peak

DC Input not allowed

Efficiency typ. 91.0 / 91.6% at 120 / 230Vac

Losses typ. 23.7 / 22.0W at 120 / 230Vac

Temperature range -25°C to +70°C operational

Derating 6W/°C +60 to +70°C

Hold-up time typ. 46 / 47ms at 120 / 230Vac

Dimensions 60x124x117mm WxHxD

The Dimension C-Series are cost optimized power

supplies without compromising quality, reliability

and performance. The C-Series is part of the

Dimension power supply family, existing alongside

the high featured Q-series.

The C series includes all the essential basic functions

and the devices have a power reserve of 20%. This

extra current may even be used continuously at

temperatures up to +45°C. The most important

features are the small size, the high efficiency and

the wide temperature range.

The Auto-select input makes worldwide installation

and usage very simple. Defects or system failures

caused by wrongly set switches can not occur.

CS10.241

CS10.244

CS10.242

CS10.481

CS10.243CS5.241

CS10.241-S1

Less

power

PFC

inductor

C-Series

Related products

48V

output

only

100-120V

only

200-240V

Spring-clamp

terminals

3. ORDER NUMBERS

4. MARKINGS

Power Supply

CS10.481

Standard unit, 48Vdc

IND. CONT. EQ.

18WM

LISTED

UL 508

UL 60950-1

GL

Marine, pending

Accessory ZM1.WALL Wall mount bracket

ZM13.SIDE Side mount bracket

YRM2.DIODE Redundancy module

EMC, LVD

1 2 3 4 5 6 ... 19 20

Summary of Contents

Page 1 - 4. MARKINGS

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 2

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 3 - 5. AC-INPUT

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 4 - 7. HOLD-UP TIME

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 5 - 8. OUTPUT

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 6 - FFICIENCY AND POWER LOSSES

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 7

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 8 - Fig. 12-1 Front side

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 9 - 14. EMC

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 10 - CS10.481

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 11 - 16. PROTECTION FEATURES

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 12 - 18. DIELECTRIC STRENGTH

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 13

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 14

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 15

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 16 - 25. APPLICATION NOTES

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 17 - 25.3. BACK-FEEDING LOADS

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 18

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 19 - 48V, 5A, SINGLE PHASE INPUT

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Page 20 - 25.12. MOUNTING ORIENTATIONS

CS10.481 C–Series 48V, 5A, SINGLE PHASE INPUT Nov. 2006 / Rev.1.1 DS-CS10.481-EN All parameters are specified at 48V, 5A, 230Vac, 25°C ambient

Comments to this Manuals

No comments