USB 2.0 Ranger® 2101High Speed Extender SystemUser GuidePowered by ExtremeUSB®
PROBLEM CAUSE SOLUTIONLink LED on LEX unit is on, Host LED on LEX unit is off•TheHostcomputerisnot powered on.•TheLEXunitisnot conne
10NOTES
11Frequently Asked QuestionsPleasevisitIcron’swebsiteforanswerstoFAQs: http://www.icron.com/products/usb/faq.phpSpecificationsRange 100 meters
12Limited Hardware WarrantyIcron Technologies Corporation warrants that any hardware products accompanying this documentation shall be free from signi
13Obtaining Warranty ServiceTo obtain warranty service, you must contact Icron Technologies Corporation within the warranty period for a Return Materi
Technical GlossaryCategory 5 (CAT 5) Network Cabling Category 5 cable is commonly also referred to as CAT 5. This cabling is available in either soli
Icron Technologies Corporation4664 Lougheed Highway, Suite 221Burnaby, BC, V5C 5T5 Canada Tel: 1-604-638-3920 Fax: 1-604-638-3930 www.icron.com
Thank you for purchasing the Ranger 2101. Please read this guide thoroughly.This document applies to Part Numbers: 00-00231 through 00-00233 and 00-0
ContentsIntroduction ... 3Ranger Product Contents ..
IntroductionThe instructions in this guide assume a general knowledge of computer installation procedures, familiarity with cabling requirements, and
The LEX unitThe LEX unit connects to the computer using the attached USB cable. Power for this unit is provided by the USB on the Host computer.
The REX UnitThe REX unit provides a USB Type A port for standard USB devices. The REX unit allows you to connect one USB device directly. Additional
Installation guide Before you can install the Ranger 2101, you need to prepare your site. 1. Determine where the computer is to be located and set up
Connecting the LEX unit to the REX unit To ensure proper operation, it is recommended that only CAT 5 or better, Unshielded Twisted Pair cabling
Connecting a USB Device1. Install any software required to operate the USB device(s). Refer to the documentation for the USB device(s), as required
Comments to this Manuals